To make a tramp bike you first have to take off the wheels chain, sprockets, pedals, and all of the bearings,
everything!!! Clean all of the grease off and then get about a roll and a half of duct tape and take rags, clothing anything
soft around the forks and the back of the frame preventing cutting holes into your tramp.Then if you see anything else that
could cut a hole in your tramp tape some soft stuff around it.You should tape some stuff around the end of your handlebars
too if you dont have grips, then you are ready.
Remember to start out slow attempting little tricks like no footer, no handers, and then when you feel good start
busting some moves, to see more tricks go to Tramp Bike tricks page.
NOTE: also if you store your bike outside or over the winter, be sure to check the front forks and the back of
the bike and see if anything has ripped through.
If is good to retape the bike every year just for added padding.
Remember to start out slow not pulling sick tricks. Once you get the feel of the bike go the theTramp Bike Tricks page and try some tricks. Also you should wear some protection in case you miss the bike and it goes flying all over.